New roofs installed by GAF Master Elite crews in Brazos County

Roof Installation Bryan TX Built for Texas Weather

Roof Installation Bryan TX means tearing off the old deck and building a watertight roof system that handles 100-degree summers and spring hail. We install asphalt shingles, standing-seam metal, and TPO flat roofs for homeowners across Brazos County. If your roof is 18 to 25 years old, leaking, or storm-damaged, we tear off, deck-check, and install in two to four days.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

Call Now (979) 316 9392 → No spam. No obligation. Just practical help.
Local Roof Repair team in Bryan
Careful work. Honest options.
About this service

Roof Installation Bryan TX: What the Job Actually Involves

Roof Installation Bryan TX is the full tear-off and rebuild of your roof system, from the decking up to the ridge cap. We strip the old shingles with a shingle ripper, inspect the roof decking for soft spots, then nail down new underlayment, ice and water shield in the valleys, and roof flashing around every penetration. The finished assembly includes new drip edge, ridge vent, and pipe boots, so water never finds a seam to slip through.

Bryan roofs take a beating. Summer attic temps push past 140 degrees, spring storms drop golf-ball hail, and the humidity off the Brazos River works on every nail head. That is why we install GAF, Owens Corning, and CertainTeed systems rated for 110 mph wind, not builder-grade three-tab. If you are searching for Roof Installation near me Bryan TX, we serve ZIP codes 77802, 77803, and 77808 with same-week estimates.

  • ✓ Cuts Summer Cooling Costs
  • ✓ Stops Leaks Before They Spread
  • ✓ Raises Wind and Hail Ratings
  • ✓ Adds Resale Value in Brazos County
What's included

What Our Roof Installation Includes

Every roof installation starts with a full tear-off, because nailing new shingles over old ones traps heat and hides deck damage. Here is what comes standard on our Bryan installs, and what we quote separately if your roof needs it.

✓

Full Tear-Off and Disposal

We strip every layer of old roofing down to the deck, then haul it off in a roll-off dumpster. No overlays, no shortcuts. You see the bare deck before we build back up, so there are no surprises hiding under the new roof.

✓

Decking Inspection and Repair

We check the roof decking for soft spots and delamination, then replace any rotted sections with new decking. We also inspect fascia board at the eaves. Solid decking is what lets shingles nail down flat and seal properly.

✓

Underlayment and Ice Shield

Synthetic roofing underlayment covers the whole deck, with ice and water shield in valleys, around chimneys, and along eaves. This is the layer that actually stops water. Shingles shed most of it, but the underlayment catches what gets past.

✓

New Flashing and Venting

We install new roof flashing at every wall, chimney, and penetration, plus new pipe boots and drip edge. Ridge vent and intake vents get sized to your attic. Correct venting is what keeps the roof deck from cooking in July.

✓

Magnetic Nail Sweep

Before we leave, we run a magnetic sweeper across the lawn, driveway, and flower beds to pick up stray nails. We also blow off the gutters and walkways. Your kids and your car tires will thank you.

How it works

Our Roof Installation Process, Step by Step

01

Free Inspection

We walk the roof, check the decking with a moisture meter, and photograph every problem area. You get a written scope with material options and a price the same day. No charge, no pressure, no salesman camping in your driveway.

02

Material Selection

You pick from asphalt shingles, metal roofing panels, or TPO membrane for flat sections. We bring samples so you can see the color against your brick. We confirm the manufacturer warranty tier, whether that is GAF Master Elite or Owens Corning Preferred.

03

Tear-Off and Deck Check

The crew lays tarps over your landscaping, then strips the old roof with shingle rippers and roofing hammers. We replace any rotted roof decking and fascia board before a single new shingle goes down. This is the step cheap crews skip.

04

Installation Day

We nail the underlayment, set ice and water shield in valleys and around chimneys, then run the shingle courses with a roofing nail gun and chalk line. Ridge vent, drip edge, and flashing get installed the same day. A magnetic sweep clears nails from your lawn.

05

Final Walk and Warranty

We walk the finished roof with you, show you the ridge line and venting, and hand over the warranty documents. We register the manufacturer coverage in your name. If anything looks off in the first year, you call us and we come back.

Tools & methods

Tools and Methods We Use on Every Install

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Roofing nail gun

Drives shingle nails to the correct depth and angle at consistent speed, so the field goes down evenly and the shingles seal.

Shingle ripper

Strips old shingles and underlayment during tear-off without gouging the decking underneath.

Moisture meter

Checks the roof decking for hidden moisture before we nail new shingles over it.

Infrared camera

Finds water intrusion and wet decking that is invisible to the eye, especially around chimneys and valleys.

Chalk line

Snaps straight reference lines so shingle courses stay level across the whole roof plane.

Safety harness and ladder stabilizer

Keeps our crew tied off and the ladder secure on steep pitches and two-story roofs.

Leaf blower

Clears granules, debris, and nails from the roof, gutters, and walkways at the end of the job.

Real results

Before and after.

Hail-Damaged Shingle Roof in Edgewater

Before

A 2,100 square foot home had bruised and missing shingles across the south slope after a spring hailstorm. The homeowner had three ceiling stains and a tarp over the worst section. The insurance claim was approved but the scope needed documentation.

After

We tore off the old roof, replaced two sheets of decking, and installed Class 4 impact-rated architectural shingles with new flashing and ridge vent. The install took three days. The ceiling stains were painted over after the leaks stopped.

Original 1970s Roof in Bonham

Before

A ranch-style house still had its original three-tab shingles, now brittle and curling at the edges. The valleys leaked into the attic, and the turtle vents had not worked properly in years. The homeowner was patching every spring.

After

We stripped the roof, replaced four sheets of rotted decking, and installed architectural asphalt shingles with ice and water shield in the valleys. Ridge vent replaced the old turtle vents. The job took four days, and the attic now vents properly.

Flat Roof Replacement in North Bryan

Before

A rental property had a flat section over the back porch with ponding water and a failing membrane. The tenant reported a leak near the door frame. The old membrane had blistered and separated at the seams.

After

We removed the old membrane, replaced the wet decking, and installed a new TPO membrane with proper slope to the drain. The leak stopped, and the flat section now sheds water instead of holding it. The job took two days.

Problems we solve

Roof Problems a New Installation Solves

Most roofs we replace in Bryan were failing in ways the homeowner could see but not fix. Here are the problems a new installation puts behind you.

Ask a pro →
01

Recurring roof leaks every storm season

We tear off the failing roof and rebuild the whole system with new underlayment, ice and water shield, and flashing. One installation replaces the patch cycle with a watertight roof and a manufacturer warranty you can actually use.

↗
02

Missing and curling shingles after hail or wind

We inspect with a HAAG Certified Inspector eye, photograph the damage, and install a new impact-rated shingle roof. We write the scope in the format your adjuster expects, which speeds up the claim and reduces your out-of-pocket cost.

↗
03

Ponding water on flat or low-slope sections

We install TPO membrane or EPDM membrane on flat sections with proper slope and drainage. The new membrane is heat-welded or adhered as one continuous sheet, so there are no seams for standing water to find.

↗
04

Rotted fascia and soffit from years of overflow

During installation we replace rotted fascia board and soffit panels, then install new drip edge and gutter coil so water leaves the roof cleanly. The roof edge is finished, not just covered up.

↗
Proof you can check

Licensed, Certified, and Reviewed in Bryan

✓
GAF Master Elite ContractorGAF
✓
Owens Corning Preferred ContractorOwens Corning
✓
CertainTeed SELECT ShingleMasterCertainTeed
✓
HAAG Certified InspectorHAAG Engineering
✓
OSHA 10 and OSHA 30 Safety CertifiedOccupational Safety and Health Administration
Customer reviews

What Bryan Homeowners Say About Our Roofs

★★★★★
“Our 20-year-old shingles were curling and we had a leak over the garage. The crew tore off the old roof, replaced three sheets of decking, and had the new shingles on in three days. They tarped the flower beds and magnet-swept the driveway. The leak is gone and the attic runs cooler.”
MT

Marcus T.Homeowner, Pecan Ridge

✓ Verified
★★★★★
“Our 1940s house has a steep roof and a flat section over the back porch. They installed architectural shingles up top and TPO membrane on the flat part, which nobody else suggested. Two summers later, no ponding water and no leaks. They knew exactly what an older Bryan house needs.”
RK

Raymond K.Homeowner, Woodville

✓ Verified
Good questions

Roof Installation Questions Bryan Homeowners Ask

(979) 316 9392 →

Most asphalt shingle roof installations in Bryan run $9,500 to $18,000 for a typical 2,000 to 2,500 square foot home in 2026. Metal roofing panels push that to $18,000 to $32,000. Steep pitch, multiple layers of tear-off, and new decking add cost. We give you a written price after inspecting the roof, not a phone guess.

A standard shingle tear-off and install takes two to four working days on most Bryan homes. Larger roofs, steep pitches, or decking replacement can stretch it to five or six days. We tarp and protect your property each night, and we do not leave a roof open to the weather overnight.

Architectural asphalt shingles are the best value for most Bryan homes, balancing cost, hail resistance, and a 30 to 50 year lifespan. Metal roofing panels last 40 to 70 years and reflect heat, which helps in our summers. Flat or low-slope sections need TPO membrane or EPDM membrane, not shingles. We match the material to your roof pitch and budget.

Bryan Roof Repair Experts installs roofs across Brazos County, including Edgewater, Austin's Colony, and The Traditions. We are a GAF Master Elite and Owens Corning Preferred contractor, licensed and insured in Texas. Every install is permitted and inspected. Call (979) 316 9392 for a free same-week estimate.

Ready when you are

Get Your Roof Installation Bryan TX Estimate Today

Call (979) 316 9392 and we will inspect your roof this week. You get photos, a written scope, and a firm price before any work starts. Licensed, insured, and warrantied in Brazos County.

Get Free Estimate (979) 316 9392 →
Request an appointment

Call Bryan Roof Repair Experts

Call us at (979) 316 9392 and you get a real person who can schedule your inspection, not a call center. We answer Monday through Friday from 8:00 to 18:00, and we run 24/7 for emergency roof repair in Bryan. Leave a message after hours and we call back first thing.

Call anytime(979) 316 9392Email the office[email protected]
Office hoursOpen 24 hours · 7 days a week
Tap to call(979) 316 9392