Soft spots around chimneys and skylights
We replace the flashing, cut out the saturated decking, and install new wood with ice and water shield at the penetration. The repair is watertight from the decking up, and we water-test it before we leave.
Roof Decking Repair Bryan TX starts with finding the rot before it spreads. We pull the shingles back, cut out the damaged plywood or OSB, and sister in new decking that holds nails and carries load. If your ceiling has a sag, your attic smells damp, or a storm pushed water past the underlayment, we handle the structural fix, not just the surface patch.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (979) 316 9392 → No spam. No obligation. Just practical help.
Roof decking is the plywood or OSB layer nailed to your rafters. It carries the weight of your shingles, holds the fasteners, and keeps the roof plane flat. When it gets wet and stays wet, the wood delaminates, turns soft, and stops gripping nails. Roof Decking Repair Bryan TX means cutting out the failed sections, replacing them with new decking, and re-nailing to code so the shingles above have something solid to bite into.
Bryan roofs take a beating. Summer attic temps push 140 degrees, then spring storms drop hail and drive rain sideways under lifted shingles. In older homes near Historic Downtown Bryan, we find 3/8-inch decking that was undersized from the start. One slow leak at a chimney or skylight and the sheathing rots from the underside out. If you have been searching for Roof Decking Repair near me Bryan TX, the soft spot you felt walking the roof is usually the tip of it.
Every decking repair starts with a full inspection and a written scope, so you know exactly what we are replacing and why. The list below covers what is standard on a Bryan decking job. If we find something outside the scope while the roof is open, we stop and walk you through it before doing any extra work.
We walk the roof and crawl the attic, using a moisture meter and infrared camera to map every wet or soft section. You get photos of each area and a written scope before we cut anything. Most inspections take 45 to 60 minutes.
We pull shingles, underlayment, and flashing from the repair zone, then cut out the damaged decking along the rafter lines with a chalk line and utility knife. The framing gets inspected and treated before any new wood goes down.
We install new plywood or OSB matched to your existing thickness, nailed to the correct schedule with a roofing nail gun. The roof plane is leveled and sistered to sound rafters so the decking carries load the way it was built to.
New ice and water shield goes down at the eaves and valleys, followed by roofing underlayment across the repair. We reinstall or replace flashing at chimneys, walls, and vents, sealing every penetration with roof sealant.
We reinstall shingles, ridge caps, and vents to match the existing roof, then water-test the repair and clear your gutters of debris. You get before-and-after photos and a written workmanship warranty before we leave.
We walk the roof and crawl the attic. A moisture meter and infrared camera confirm which sections are wet, and a probe finds soft wood that looks fine from above. You get photos of every bad section and a written scope the same day.
We remove shingles, underlayment, and flashing from the repair zone with a shingle ripper and pry bar. Decking is exposed down to the rafters so we can see the full extent of the rot. Most single-area tear-offs take 2 to 3 hours.
Rotten sections get cut out along the rafter lines with a utility knife and chalk line, then replaced with new decking nailed with a roofing nail gun. We match thickness to the existing deck so the roof plane stays even. Larger areas run 4 to 6 hours.
New ice and water shield goes down at the eaves and valleys, then roofing underlayment across the repair. We reinstall flashing, shingles, and ridge caps, sealing every penetration with roof sealant. This stage takes 3 to 5 hours depending on the area.
We water-test the repair zone, check the attic for light gaps, and clean the gutters of debris with a leaf blower. You get before-and-after photos and a written warranty on the decking work before we pull out of the driveway.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Reads the water content in decking and framing so we know exactly which sections are wet. It catches damage that looks fine from the roof surface.
Shows temperature differences that reveal trapped moisture behind shingles and underlayment. We use it to map the full extent of a leak before we cut.
Lifts shingles and underlayment without damaging the surrounding roof. Lets us expose the decking cleanly so the repair zone stays tight.
Drives nails to the correct schedule and depth on new decking. Consistent fastening is what gives the decking its holding power.
Marks and cuts decking along rafter lines for a clean, square replacement. Straight cuts mean the new wood fits tight and the plane stays level.
Seals flashing, vents, and penetrations after the decking is replaced. A proper seal keeps water out of the new wood.
Keeps our crews safe on steep and tall roofs. OSHA 10 and OSHA 30 training means we work at height the right way.
A homeowner in Woodville had a ceiling stain that kept coming back after every rain. Three previous repairs from the top had not stopped it. We pulled the shingles back and found the decking around the chimney rotten across a 4-foot section, with the flashing rusted through.
We cut out the rotten decking, sistered new wood to the rafters, and installed new decking matched to the existing thickness. New ice and water shield and flashing went down, then new shingles. The repair took one day, and the ceiling stain has not returned.
A 1950s home near Historic Downtown Bryan had 3/8-inch decking sagging between the rafters. The hallway ceiling had a visible dip, and walking the roof felt spongy in two spots. The wood had been wet long enough that nails were pulling free.
We removed the damaged decking, sistered new wood to the rafters, and leveled the roof plane before installing new decking. The ceiling line is straight again, the roof feels solid underfoot, and the new shingles sit flat across the span.
After a spring storm, a homeowner in The Traditions noticed shingles missing along the west edge. The wind had gotten under the shingles and pulled nails out of the decking. The exposed wood had soaked up rain for two days before we got there.
We replaced the lifted decking, re-nailed the edge to code, and reinstalled shingles with proper fastening. The repair was water-tested and has held through two more storm seasons without lifting. Total time on site was about six hours.
Rotten decking rarely announces itself. By the time you see a ceiling stain or feel a soft spot, the wood has usually been wet for months. Here are the decking problems we fix most often in Bryan and what happens if they are left alone.
Ask a pro →We replace the flashing, cut out the saturated decking, and install new wood with ice and water shield at the penetration. The repair is watertight from the decking up, and we water-test it before we leave.
We sister new decking to the rafters, level the plane, and re-nail to code. The roof carries weight evenly again, and shingles sit flat instead of bridging a dip that collects water.
We remove the damaged shingles and underlayment, replace the rotten decking, and reinstall ice and water shield at the eaves. The next freeze sheds water instead of forcing it under the roof.
We re-nail or replace the lifted decking, reinstall shingles with proper fastening, and check the full roof plane for weak spots. The edge holds through the next wind event instead of peeling back again.
“We had a leak around the chimney that three other guys tried to fix from the top. Bryan Roof Repair Experts pulled the shingles back and found the decking was rotten across a 4-foot section. They replaced it, re-flashed the chimney, and we have not seen a drop since. Took one day.”
Marcus T.Homeowner, Woodville
✓ Verified“After the hail storm, our adjuster said the decking was fine. This crew walked the attic with a moisture meter and found three soft spots the adjuster missed. They documented everything with photos, replaced the decking, and our claim got approved for the full scope. Straight shooters.”
Denise R.Homeowner, The Traditions
✓ Verified“Our 1950s house had 3/8-inch decking that was sagging between the rafters. They sistered new wood to the framing, leveled the plane, and re-roofed the section. The ceiling line in the hallway is straight again. Fair price and they cleaned up every nail.”
Gary L.Homeowner, Historic Downtown Bryan
✓ VerifiedMost decking repairs in Bryan run $450 to $1,800 in 2026, depending on how many sheets are replaced and how much shingle work is needed to get to them. A single soft spot around a chimney or vent often lands near the low end. Full-section replacement across a 10x10 area with new underlayment and flashing sits at the higher end. We give you a fixed written price after inspection.
Three signs show up most: a spongy feel when you walk the roof, a sagging ceiling line in the attic, and a musty smell that does not go away. From inside, look for dark streaks on the underside of the decking or daylight around nails. A moisture meter confirms it in seconds. If you see any of these, get it checked before the next storm.
Yes. We repair decking across Bryan and Brazos County, from Downtown Bryan to Woodville and out to Lake Bryan. We cut out the rotten sections, replace them with new decking matched to your existing thickness, and re-roof the area with new underlayment and flashing. Most repairs finish in one day.
Bryan Roof Repair Experts handles decking repair, and we are set up for the structural side of the job, not just shingles. Our crews are OSHA 10 and OSHA 30 trained, we are HAAG Certified Inspectors, and we install GAF and Owens Corning systems. Call (979) 316 9392 and we will get eyes on your roof, usually the same day.
Soft decking gets worse with every rain. Call (979) 316 9392 and we will inspect your roof, show you exactly what is damaged, and give you a fixed price before we start. Same-day estimates across Bryan and Brazos County.
Book Inspection (979) 316 9392 →Call us at (979) 316 9392 and you get a real person who can schedule your inspection, not a call center. We answer Monday through Friday from 8:00 to 18:00, and we run 24/7 for emergency roof repair in Bryan. Leave a message after hours and we call back first thing.