Fascia and Soffit Repair Bryan TX protects the two roof edges most homeowners never see until water is already inside. We replace rotted fascia board, reattach sagging soffit panels, and seal every gap so rain, wasps, and squirrels stay out. Whether you are in Edgewater or near Downtown Bryan, we inspect, price, and repair the same week.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now (979) 316 9392 → No spam. No obligation. Just practical help.
Fascia and Soffit Repair Bryan TX is the trade work of replacing or reinforcing the horizontal trim board that caps your rafter tails (fascia) and the underside panels that close off the eave (soffit). Fascia holds your gutter coil and roof edge flashing; soffit hides the rafters and feeds intake air to your attic vents. When either one rots, the damage travels fast: water wicks into roof decking, insulation sags, and pests find a doorway into the attic.
Bryan homes take a specific beating. Summer heat pushes attic temperatures past 140 degrees, which bakes paint off fascia board and dries the caulk line around gutter hangers. Then spring storms drop two inches of rain in an hour, and any soft spot in the fascia lets water run behind the gutter and straight into the wall. If you have been searching for Fascia and Soffit Repair near me Bryan TX, the fix is usually a half-day job once we find the true source.
Every fascia and soffit repair starts with an inspection and ends with a walkthrough. Here is what is covered in a standard repair, and what we price separately if we find it behind the trim.
We probe the fascia with a pry bar, check the soffit panels by hand, and scan the attic side with an infrared camera. You get photos of every soft spot before we price the repair.
We cut out the rotted fascia board, replace it with new material matched to the original profile, and fasten it to the rafter tails with a roofing nail gun. We replace only what is soft, not the whole run.
Sagging or crushed soffit panels get cut to the original vent pattern and refastened. We keep the intake vents open so the attic keeps breathing the way it was designed to.
Every joint gets a paintable roof sealant, then we prime and paint the new wood to match the existing trim. The repair blends in instead of showing up as a bare strip of lumber.
If the gutter pulled loose when the fascia failed, we re-secure it to the new board and check the pitch so water runs to the downspout instead of sitting in the run.
We haul off the old board and panels and blow the driveway and beds clean before we leave. You should not be able to tell we were there except for the repair itself.
Call (979) 316 9392 and describe what you see: peeling paint, a sagging gutter, or a soft spot when you press the fascia. We book a same-day or next-day inspection, and you get a text when the technician is on the way.
We walk the perimeter with a ladder stabilizer and a moisture meter, then probe the fascia board with a pry bar to find soft wood. An infrared camera checks the attic side for hidden moisture. The inspection takes 30 to 45 minutes.
You get a written price before we start: materials, labor, and disposal on one line. No surprise add-ons. If we find rotted roof decking behind the fascia, we show you the photo and price that repair separately before touching it.
We pull the old fascia board, cut the new board to length, and fasten it with a roofing nail gun. Soffit panels get cut to the original vent pattern and secured to the rafter tails. Most jobs take one day; long runs take two.
We caulk every joint with a paintable roof sealant, prime and paint the new wood to match, and re-hang the gutter. A leaf blower clears the driveway and flower beds. You walk the job with us before we pack the truck.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Reads the water content inside the fascia board and soffit panels so we replace only the wood that is actually wet, not the whole run.
Scans the attic side of the eave for hidden moisture behind the trim, which catches leaks that have not yet stained the ceiling.
Fastens new fascia board and soffit panels to the rafter tails quickly and consistently, with the correct nail spacing for the material.
Probes the fascia for soft spots and pulls old board and nails without splitting the rafter tails behind it.
Applies a paintable roof sealant to every joint so water cannot slip behind the new board and start the rot cycle again.
Keeps the ladder off the gutter and spreads the load, which protects the gutter coil and keeps the crew stable on two-story eaves.
Clears sawdust, old paint chips, and debris from the driveway, walkway, and flower beds before we leave the property.
A 30-foot run of fascia board behind the back gutter was soft to the touch and the gutter had pulled two inches away from the roof edge. Water was running behind the gutter and staining the soffit.
We replaced the full run with new fascia board, re-hung the gutter with new hangers, and painted the new wood to match. The gutter now drains to the downspout, and the soffit stain has stopped spreading.
A spring hail storm chipped paint off 60 feet of fascia and dented the gutter coil along the front of the house. The homeowner filed a claim but the adjuster needed better documentation.
We photographed and measured the damage, replaced the fascia and gutter sections, and provided a HAAG-style report. The claim was approved, and the new trim matches the original color.
Four soffit panels over the back porch had sagged and pulled loose, and the homeowner was hearing squirrels in the attic. The gap was wide enough to fit a golf ball.
We cut and installed four new soffit panels matched to the original vent pattern, sealed the edges with pest-rated mesh, and checked the rest of the perimeter. The attic is sealed and the intake vents are open.
Most fascia and soffit calls start with one of these five problems. Each one gets worse with every rain, so the repair is cheaper the earlier you call.
Ask a pro →We replace the rotted fascia board, re-secure the gutter to solid wood, and check the pitch so the run drains correctly. Most re-hangs take two to three hours and include new hangers where the old ones pulled out.
We probe the board with a moisture meter, cut out the soft section, and replace it with new material matched to the original profile. We prime and paint the new board so it sheds water instead of absorbing it.
We cut new soffit panels to the original vent pattern and fasten them to the rafter tails. We seal the edges with a pest-rated mesh so animals cannot pull the panel loose again.
We scrape the loose paint, repair any soft wood, prime the bare spots, and apply a coat that matches the existing trim. If the board is already rotted, we replace it before painting.
“Our soffit was sagging over the back patio and we had wasps getting into the attic. The crew replaced four panels and a rotted fascia board in one afternoon. They matched the vent pattern and painted the new wood to match. No more bugs, and the gutter is straight again.”
Marcus T.Homeowner, Edgewater
✓ Verified“After the spring hail, our fascia looked like it had been sandblasted. Bryan Roof Repair Experts documented everything with photos and worked with our adjuster. They replaced 60 feet of fascia board and re-hung the gutter. The written price matched the final invoice exactly.”
Dana R.Homeowner, Austin's Colony
✓ Verified“This is a 1940s house with original wood trim, and I did not want a repair that stood out. They matched the profile and the paint, and you cannot tell where the new board starts. They also found a soft spot behind the gutter that two other companies missed.”
Ken W.Homeowner, East Side Historical District
✓ VerifiedMost fascia and soffit repairs in Bryan run $350 to $1,800 in 2026, depending on linear footage and how much rot we find. A single 20-foot run with new fascia board and paint lands near the low end. Full-perimeter replacement with new soffit panels and gutter re-hang runs higher. We give you a written price before work starts.
The two main causes are water and heat. Overflowing gutters soak the fascia board every time it rains, and Bryan's summer attic heat bakes the paint until bare wood is exposed. Woodpeckers and squirrels widen small gaps, and hail can crack the paint film. Once the board stays wet, rot sets in within one or two seasons.
Yes. We repair and replace fascia board and soffit panels across Bryan and Brazos County, including Edgewater, Austin's Colony, and the East Side Historical District. We handle the wood, the paint, and the gutter re-hang in one visit. Most jobs finish in a day, and we clean up before we leave.
Call Bryan Roof Repair Experts at (979) 316 9392. We are a local crew with HAAG Certified Inspectors on staff and OSHA-trained installers. We work on wood, James Hardie, and LP SmartSide fascia, and we tie the repair into the roof flashing so water cannot get behind it. Same-week scheduling is standard.
Roof RepairFascia rot often starts at the roof edge, where flashing and shingles meet the trim. We repair the roof and the fascia together so water stops at the source instead of running behind the gutter.Explore →
Roof Leak RepairA leak that shows up on the ceiling often starts at the eave. We trace it with a moisture meter and infrared camera, then fix the fascia, flashing, and shingle course that let the water in.Explore →
Shingle Roof RepairWhen shingles at the eave are curling or missing, the fascia board underneath stays wet. We replace the damaged shingles and the rotted fascia in the same visit so the repair holds.Explore →
Metal Roof RepairMetal roofing panels expand and contract with Bryan's temperature swings, which can pull the eave trim loose. We reseal the edge and replace any fascia board that has softened behind it.Explore →
Flat Roof RepairFlat roofs shed water toward the edge, so a failing fascia is often the first sign of ponding water. We repair the fascia and check the EPDM or TPO membrane at the same time.Explore →
Tile Roof RepairClay and concrete tiles are heavy, and a sagging fascia can mean the eave framing is overloaded. We inspect the rafter tails, repair the fascia, and reset any cracked tiles at the edge.Explore →
Emergency Roof RepairStorm tore your gutter and fascia loose? We tarp the edge, secure the gutter, and schedule the permanent repair. Emergency calls go out the same day across Bryan.Explore →
Storm Damage Roof RepairWind and hail strip paint off fascia and crack soffit panels. We document the damage with a HAAG-style photo report, repair the trim, and tie the work into your insurance claim.Explore →Call (979) 316 9392 for a same-week inspection and a written price. We are licensed, insured, and warrantied, and we clean up before we leave. If your gutter is hanging or your soffit is sagging, do not wait for the next storm.
Get Free Estimate (979) 316 9392 →Call us at (979) 316 9392 and you get a real person who can schedule your inspection, not a call center. We answer Monday through Friday from 8:00 to 18:00, and we run 24/7 for emergency roof repair in Bryan. Leave a message after hours and we call back first thing.